Open 24/7Licensed in VirginiaInsured and bonded

Call (202) 600-6220

Glass Shower Door Sagging or Won't Close? Causes and Fixes

A glass shower door that sags, rubs the curb or will not close has almost always dropped on its hinges or pivots: the screws have loosened, the hinge has worn, or what the hinge is fixed into has given way. On a slider, it is usually the rollers. Most of the time it is a repair, not a new door, but on a heavy frameless door the hinges should not be loosened by hand while the glass is hanging. Here is how to find the cause for your type of door and what the fix involves.

Which kind of door do you have?

The cause, and the fix, depend on how the door is hung.

Thick glass on two or three clamp hinges fixed to the wall or a fixed panel. The glass is heavy, so any wear at the hinges shows as a drop at the handle side.

Framed or pivot door

A door in a metal frame that swings on pins at the top and bottom, or on a long hinge strip. Worn pivots or a loose frame let it drop and rub.

Panels hung on rollers along a top rail. When a roller wears or slips, the door rides low, drags or will not meet the wall.

What your door is doing, and why

Find the line that matches. If water is also getting out, the fix is often the same; see glass shower door leaking.

What the door doesMost likely causeThe usual fix
Handle side has dropped and rubs the curbHinge screws loosened, or a hinge wornDoor lifted and set level, hinges tightened or replaced
Will not latch or meet the magnet stripDoor has dropped, or the strip has been knocked out of lineDoor realigned; strip reset or replaced
Swings open or closed by itselfDoor or wall out of plumb, or a self closing hinge wornDoor set plumb; hinge adjusted or replaced
Gap at the top or along the hinge sideHinge pulling away from the wallCheck what the hinge is fixed into; refix into solid backing
Slider drags, rides low or jumps the trackWorn or broken roller, or roller set too lowNew rollers, set to the right height
Framed door rubs at the bottom cornerWorn pivot, or the frame has movedNew pivot parts, frame refixed

Safe checks you can do first

These need no tools beyond your eyes and a level, and they tell us a lot.

1. Watch the gap

Close the door slowly and look at the gap along the top and the handle side. A gap that is wider at the top on the hinge side, and tighter at the bottom on the handle side, means the door has dropped.

2. Look at the hinges

Check for a hinge that has rotated, a cracked hinge body, a gap between the hinge and the wall, or cracked tile or grout around it.

3. Check the glass edges

Look along the bottom and handle edges for chips where the glass has been rubbing. A chipped edge on tempered glass is a weak spot and should be looked at.

4. Slider: look at the rollers

From outside, look up at the top rail. A roller sitting crooked, missing a wheel or off the rail explains a door that drags.

What not to do on heavy glass

  • Do not loosen the hinge screws on a frameless door while it is hanging. The glass can drop onto the curb or swing into the tile, and a knock on the edge of tempered glass can make it shatter.
  • Do not force it shut past the point where it rubs. That grinds the bottom edge.
  • Do not hang towels or weight on the door while it is sagging; that loads the hinges further.
  • Do stop using it if a hinge is cracked or pulling out of the wall. Hinges do fail: the U.S. Consumer Product Safety Commission has recalled shower doors whose pivot hinges could fail and let the glass panel separate from its frame.

If the glass has already broken, keep out of the shower and see why a glass shower door shatters for what to do next.

Why the fix sometimes does not last

Tightening a sagging door works if the hinge is sound and fixed into something solid. When it drops again soon after, one of these is usually the reason.

Hinges fixed into tile only

Heavy glass needs its hinges fixed into studs or solid blocking behind the tile. Screws held only by tile and drywall slowly pull loose.

A worn hinge

Hinges wear inside, especially self closing ones. A worn hinge can be tightened but will drop again; it needs replacing with a matching part.

A wall that has moved

Settling or a wall that was never plumb puts the door out of line with the fixed panel or the strike side.

Too much load

Towel bars on the glass, people leaning on the door to step out, or a door too big for the hinges chosen.

How we fix it

We support the glass, check the hinges or rollers and what they are fixed into, replace worn parts with matching ones, and set the door level and plumb so it closes, seals and stays put. If the backing is the problem, we tell you before we start. All of this is part of our shower door repair work across Northern Virginia and Maryland. If the door is beyond repair, see glass shower door installation or frameless vs framed shower doors.

PHOTO NEEDED (only admins see this): a frameless shower door that has dropped at the handle side with an uneven gap, and the same door after the hinges were reset, from a real job. Landscape 1600x1000, WebP.

It has dropped on its hinges or pivots. The hinge screws have loosened, a hinge has worn, or the hinges are fixed into tile with no solid backing and are pulling out. On a slider, a worn roller makes the door ride low.

Usually because the door has dropped and now rubs the curb or misses the magnet strip, or because the strip has been knocked out of line. A wall or door that is out of plumb can also stop it closing.

Checking that the hinge screws are snug is fine, but do not loosen them while the door is hanging. The glass is heavy and can drop or swing into the tile, and a knock on the edge of tempered glass can shatter it.

A small drop is not dangerous by itself, but it grinds the bottom edge and loads the hinges. Stop using the door if a hinge is cracked or pulling out of the wall, and have it looked at.

The door or the wall is out of plumb, so the glass swings to its low side, or a self closing hinge has worn. Setting the door plumb or replacing the hinge fixes it.

Shower door dropped or won't close?

Send a photo of the door and its hinges, or call (202) 600-6220.