Glass Shower Door Leaking at the Bottom or Sides? How to Find the Leak
A glass shower door that leaks at the bottom almost always has a worn or missing sweep; one that leaks at the sides usually has a worn side seal or has dropped out of line so it no longer closes tight. Find the exact spot first, with a short water test, because the fix for each spot is different. Here is the test, what each leak point means, and the leaks that are not the door at all.
- Shower door repair across the DMV
- Free estimates
- Hablamos español
Find the leak in ten minutes
Dry the floor and the outside of the door completely, then wet one area at a time with a cup or a hand shower. Wait a minute after each one and look for a drip outside.
1. The bottom edge
Pour water along the inside of the door where it meets the curb. A drip right below the door points to the sweep or the curb.
2. The hinge side
Spray the gap between the door and the wall or the fixed panel, top to bottom. Water out here points to a side seal or a door that has dropped.
3. The closing side
Spray the edge where the door closes. A gap you can see light through, or a seal that no longer touches, is the leak.
4. The corners and joints
Spray the corners where glass, wall and curb meet. Water here usually means failed caulk, not the door itself.
If none of these drip but the floor is still wet after a real shower, the water is likely coming from the spray itself, or from somewhere other than the door. Both are covered below.
What each leak point means
| Where it leaks | Most likely cause | The fix |
|---|---|---|
| Under the door | Sweep torn, flattened, hard or missing | New sweep cut to the door width and matched to the glass thickness |
| Hinge side gap | Side seal worn, or the door has sagged on loose hinges (see why a shower door sags) | Tighten or replace hinges, realign the door, new seal |
| Closing edge | Door no longer meets the wall or panel evenly | Realign the door, then a new strike side seal or magnetic strip |
| Bottom track (framed and sliding doors) | Drain holes in the track blocked by soap, scale or caulk | Clear the holes, take caulk out of the inside of the track |
| Where two sliding panels overlap | Worn overlap seals, or rollers that have dropped a panel out of line | New seals and rollers, panels set level again |
| Corners and fixed panel joints | Cracked or missing silicone | Old silicone cut out, joint cleaned and dried, new silicone |
Frameless, framed and sliding doors leak in different places
The door type tells you where to look first.
A frameless door is built with small gaps so it can swing. The sweep and the side seals close those gaps, so on a frameless door they are the first place to look. A heavy door on worn hinges also sags, which opens the gap on the closing side.
A sliding door leaks where the panels overlap, where they meet the wall, and over the bottom track. Worn rollers let a panel drop, which opens all three. Blocked drain holes in the track are the other common cause.
Framed doors
The frame and its track carry the water back into the shower through small drain holes. Leaks usually come from those holes clogging, from caulk run along the inside of the track, or from the frame sealant drying out at the wall.
Caulk on the wrong side makes a framed door leak
On a framed or sliding door, the track is meant to catch water and let it run back into the shower through its drain holes. If someone runs caulk along the inside of the track, the water has nowhere to go, fills the track and spills over the outside. The track should be sealed on the outside edge, where it sits on the curb, and left open on the inside.
On a frameless door, silicone goes along the joints between fixed glass, wall and curb. The door itself is never caulked; it seals with its sweep and side seals.
When it is not the door at all
If the water test above stays dry, look at these before paying for new seals.
The shower head
A head aimed at the door, or a hand shower used close to the glass, drives water through gaps that are fine in normal use. Turn the head toward the wall and see if the leak stops.
The curb
The top of the curb should slope slightly into the shower. If it is flat or slopes out, water runs under even a good sweep.
Grout and tile
Water stains on the ceiling below, or a wet floor away from the door, can come from cracked grout or a failed pan, not the door.
The valve or drain
A leak only while the water runs, inside the wall or under the floor, is a plumbing question. That is a job for a plumber, not a glass company.
Fix it soon, and dry the floor
A small leak each day keeps the floor, the trim and the subfloor wet. The EPA’s guidance on mold in the home says to dry things that get wet within 24 to 48 hours, and a leaking door never lets the floor get there. Wipe up after each shower until the door is fixed.
Most door leaks are a repair, not a new door: a sweep, a seal, a hinge adjustment or new rollers. We do all of it on our shower door repair visits, across Northern Virginia and Maryland.
- A photo of the whole door, closed
- A close photo of the bottom edge and the hinge side
- Where the water shows up after a shower
- Whether the door swings or slides
Shower door leak questions
More questions? Browse our glass repair FAQ or contact us.
Why does my shower door leak at the bottom?
Usually the sweep along the bottom of the door is torn, flattened or missing. On framed and sliding doors, blocked drain holes in the track are the other common cause.
Why does my shower door leak on the hinge side?
The side seal is worn, or the door has dropped on loose or worn hinges so the gap has opened. Tightening or replacing the hinges and fitting a new seal fixes it.
Should I caulk the inside of my shower door track?
No. The inside of a framed or sliding door track needs to stay open so water can drain back into the shower. Seal the outside edge where the track sits on the curb.
How do I find where my shower door is leaking?
Dry everything, then wet one area at a time with a cup or hand shower: the bottom edge, the hinge side, the closing side and the corners. Wait a minute after each and look for a drip outside.
Can a leaking shower door be fixed without replacing it?
Almost always. New sweeps and seals, adjusted or new hinges, new rollers on a slider, or new silicone at the joints stop most leaks. A new door is only needed if the glass or frame is damaged.
Shower door still leaking?
Send a photo of the door and where the water lands, or call (202) 600-6220 for a free estimate.