How thick are glass block mortar joints?
The home code sets head and bed joints in glass block at 1/4 inch, filled solid with type S or N mortar. Bed joints may run 1/16 inch thinner or 1/8 inch thicker, and head joints 1/8 inch either way. Curved panels allow vertical joints from 1/8 to 5/8 inch.
- Free estimates
- Open 24/7
- Hablamos español
What the code says
The International Residential Code covers this in sections R607.8 to R607.10 of chapter 6.
- Joint size: 1/4 inch head and bed joints.
- Mortar: type S or N, never retempered after initial set.
- Reinforcement: horizontal joint reinforcement at least every 16 inches.
- Splices: wires lapped 6 inches at least.
- Openings: reinforcement in the bed joints just above and below.
Joint reinforcement runs the full length of the panel but stops at expansion joints.
Laying a few blocks
Spread mortar in a full bed, not furrowed, and keep each joint close to 1/4 inch so the reinforcement sits inside the bed joint. Mortar that has started to set should not be remixed with water, since the code forbids retempering.
Read bathroom window privacy glass, or see window glass repair for a free estimate.
Related questions
- How thick is glass block?
- How big can a glass block wall or window be?
- Does a glass block wall need expansion joints?
- How is a glass block panel held in place?
- Can a glass block wall be repaired with matching block?
- All glass repair questions
From other topics
- Does a window by a bathtub need tempered glass? (glass near a tub)
Glass block wall damaged?
Send us a photo for a free estimate, or call (202) 600-6220.