Open 24/7Licensed in VirginiaInsured and bonded

Call (202) 600-6220

Does a glass block wall need expansion joints?

Yes. The home code requires expansion joints along the top and sides of a glass block panel at every structural support. Each joint must be at least 3/8 inch thick, free of mortar and debris, and filled with resilient material, so the panel can move with the framing around it.

What the code says

The International Residential Code covers this in sections R607.5 to R607.7 of chapter 6.

  • Where: top and sides, at all structural supports.
  • Width: 3/8 inch at least, and enough for the structure’s movement.
  • Fill: resilient material, with no mortar or debris.
  • Sill: a water based asphalt emulsion coat at least 1/8 inch thick before the blocks are bedded.
  • Supports: framing under the panel can deflect no more than 1/600 of its span.

What to check on an older panel

Look along the top and sides of the panel. The joint there should be a soft, resilient strip, not hard mortar. Note any cracked blocks and where they sit in the panel before asking for an estimate. Photos of the whole panel and of the cracked area help.

Read bathroom window privacy glass, or see window glass repair for a free estimate.

Cracked glass block window?

Send us a photo for a free estimate, or call (202) 600-6220.