Open 24/7Licensed in VirginiaInsured and bonded

Call (202) 600-6220

How is a glass block panel held in place?

Along its top and sides, says the home code, by panel anchors no more than 16 inches apart or by channels. Supports must resist at least 200 pounds per linear foot of panel. Anchors are embedded at least 12 inches with two fasteners, and panels set in channels sit at least 1 inch deep.

What the code says

The International Residential Code covers this in section R607.5.2 of chapter 6.

  • Anchors: 16 inches on center at most, in both jambs and across the head.
  • Embedment: 12 inches at least, with two fasteners each.
  • Channels: panel recessed 1 inch at least, sized for expansion material and sealant.
  • Single units: a one block panel must use channels.
  • Exceptions: no top support for panels one unit wide, no side support for panels one unit high.

Swapping block for a window

Before replacing a block window with a framed window, or the other way around, have the opening checked. Glass block is masonry laid in type S or N mortar, while a framed window is anchored to the wall by its maker’s instructions.

Read bathroom window privacy glass, or see window glass repair for a free estimate.

Swapping glass block for a window?

Send us a photo for a free estimate, or call (202) 600-6220.