Who counts as the manufacturer of a glass shower door under federal rules?
The fabricator. The federal safety glazing standard says fabricators are considered manufacturers of the products it covers, including shower doors and enclosures. Those products must be built with glazing that meets the standard, and glazing makers label their glass as the standard requires.
- Free estimates
- Open 24/7
- Hablamos español
What the rule says
The federal rule is 16 CFR part 1201, the Consumer Product Safety Commission’s standard for architectural glazing. This answer comes from section 1201.1(b).
- Fabricators: count as manufacturers of the covered products.
- Covered products: doors, storm doors, tub and shower enclosures, sliding patio doors.
- Glass used: must meet the standard’s impact and environmental tests.
- Labels: glazing makers label the glass as required.
The same rule makes the shop that cuts and assembles a custom enclosure responsible for the glass going into it.
What to ask for
Ask for tempered or laminated safety glass and look for the permanent mark on each panel once it is installed. A custom frameless enclosure is usually thick tempered glass, cut and drilled before tempering, since tempered glass can’t be cut afterward.
Read tempered vs laminated glass, or see frameless shower doors for a free estimate.
Related questions
- Which doors need safety glass under federal law?
- What glass is exempt from the federal safety glass rule?
- Does the federal safety glass rule cover a window over a bathtub?
- What test does federal safety glass have to pass?
- What does “glaze this side in” mean on safety glass?
- All glass repair questions
From other topics
- Does a shower door have to be tempered glass? (the building code rule)
Planning a glass shower enclosure?
Send us a photo and sizes for a free estimate, or call (202) 600-6220.