Can tempered glass be cut or drilled?
No. Tempered glass can’t be cut, drilled or notched after it has been tempered. Tempering leaves the surfaces squeezed tight and the core under tension, so cutting into it makes the whole pane shatter into small pieces. Every hole, notch and edge is made first, and then the glass is tempered.
- Free estimates
- Open 24/7
- Hablamos español
What the glass industry says
The National Glass Association’s paper on fabrication before heat treatment says the industry does not recommend working glass after it has been heat treated, because it may weaken the glass or cause it to break. It quotes the glass standard: all cutting to size, edgework, drilled holes, notching, grinding, sandblasting and etching must be done before tempering.
Tempering heats the cut glass to about 1150 °F and then cools it fast with air, which puts the surfaces in compression and the center in tension. Break through that outer layer anywhere and the stored stress releases at once.
What this means for your project
- New size or new holes? You need a new piece of tempered glass, made to measure.
- Shower doors and table tops are measured, cut and drilled first, then tempered.
- Plain glass can be cut on site, but only where safety glass isn’t required.
Compare the two safety glasses in tempered vs laminated glass, or see tempered glass for a free estimate.
Related questions
- Do glass railings have to be laminated glass?
- What kind of glass is required in a skylight?
- Is heat strengthened glass the same as tempered glass?
- Does a glass table top need to be tempered?
- All glass repair questions
From other topics
- Can you replace just the glass in a shower door? (why new shower glass is made to size)
Need tempered glass made to size?
Send us the sizes and a sketch for a free estimate, or call (202) 600-6220.